Your comments
maybe it would be better if I have some manual from you, so I dont have to try everything, my systems consist OF:
1. 1x Helvar 910 router
2. 8 x RGB DALI driver for LED, each with 3 DALI adresses
3. 4 x single adress DALI drivers
4. 2 x Helvar 315 sensor
5. 2 x Helvar 490 blind controller
6. 2 x Helvar 492 power relay
7. 1x Helvar 498 8x16A relay unit (for sockets and electric heating of floor)
- this is already working, coz i am familiar with Programming in designer
then I have KNX components:
1. UMC server
2. 2x Schneider Push-button, 4-gang plus
3. 3 x Schneider MTN6215-0310, KNX Multitouch Pro, System M
4. 1x Schneider MTN6221-0325 Room temperature control unit for properties
5. 1x Schneider MTN6730-0001 Heating actuator REG-K/6x230/0.16 A
6. 1x Schneider MTN684032 KNX power supply REG-K/320 mA
7. Ipad on the wall
8. network router
9. network switch with wifi antena
10. 2x CoolPlug Daikin with 1 x CooLinkHub for air conditioning
11. ise smart connect KNX Vaillant for heating
thank you for your naswer
Hi, yes this is done, I have set it up to KNX by second option through web interface settings, now I can see it through ETS but I cant read KNX switches and give them adresses, they are connected properly, I checked. thank you for your advice
I have domw it, but I cant search knx devices. The case is that I mees to work also with hardware knw buttons and manage knx devicea but also helvar dali devices by both knx buttons and iridium mobile, how should I do it?
Customer support service by UserEcho
I would need some manual and process of how to connect all thesye systems, what to in in iridium studio and your application and what to do in ETS5, I believe order of steps is important