Hello

I sent you the project file, everything was ok?

Hope to hear from you soon.

Hello

where do I get the connection log?, the project file I can send you.

Hello

The project was always with 2 bridges and 1 site license but just last week the finally could make a connection from the second bridge to the first bridge and put them in the same network.

when I test it, I was surprise it didn't work, that's why I'm asking what can I do? to solve this problem?

Hi Dmitry

I have change the panel to broadcast 255.255.255.255 but have the same result only works the equipment connected to the bridge 10.117.108.99 the one that has the site license.

I have made a quick test with iridium studio, I made 4 trigger buttons

In the first 2 trigger buttons I put channel 1 (command) and (feedback) of the relay connected to the bridge 10.117.108.99.

In the 3 and 4 trigger buttons I put channel 1 (command) and (feedback) of the relay connected to the bridge 10.117.108.98.

Now when I use the emulator on i3 with the developer panel test everything works fine.

So my conclusion is that: I need another site license for the other bridge?

Will this work with the same mask created for i2v2.2 ? I can see all the equipment from HDL with the scan udp option inside iridium.

The main problem is that I need to control both sides, that's the whole point of the site license.

hello

Thanks for your reply

right now i2.2 is connected to the first bridge 10.117.108.99 that has the site license.

I think I need to change it to local broadcast 255.255.255.255 and test it again