Поделитесь своими идеями, пожеланиями и примерами в этом разделе. Идеи, за которые голосуют чаще всего, будут реализованы быстрее!
Мы перевели нашу службу поддержки на новую систему технической поддержки. С 17.01.2022 мы отключили возможность создавать обращения через личный кабинет userecho. Теперь все запросы обрабатываются по почте на support@iridi.com .
Спасибо вам за ваше понимание и хорошего дня.
Pansonic Tv IP control
LonWorks Protocol (ISO IEC 14908)
We are a company which develop LonWorks devices, we are interesting in integrating iridium platform with lon devices but iridium doesn´t support this protocol.
Is there a way to integrate LonWorks with Iridium or a company which develop the driver in iridium control panels?
Regards,
Alex
IR.Log
Is it possible to log the “Dimmer Units” or “Switch/Relay Units” from a Duotecno or KNX driver?
For example:
Slow to show feedback
We have a KNX site with approximately 200 group addresses and we are experiencing a lag between sending commands and feedback showing in iRidium.
Do you have any suggestions?
Maximum number of MODBUS commands/feedbacks
is there a maximum of MODBUS commands/feedbacks in Iridium?
I'm workin on a project with about 4000 MODBUS objects.
Is this gonna work of could this give some troubles?
Merging KNX project files
BIG thank you for adding the option to merge a new knxproj file into an existing KNX driver in a project. This works.
One point to note, the text for the question that you are asked when you import a new KNX knxproj file when an existing KNX driver is in the current project.
It would sound better if you said something like, "merge knxproj file into existing knx driver" as opposed to replace, which implies that the current driver will be removed.
Thanks,
Roger
AMX tp4 file visualisation - Touchmap function
I would like to ask you if we have implemented Touch Map function of
Multi-State Bargraph in AMX visualisation ?
It is for "Value Direction" Property of General tab where can be - Vertical,
Horizontal or Touch map ...
Thank you for information
Remote access for I2control app
I was configured a iridium application for the remote access, before I2control was working fine through remote ly the ip address was appeared in the gate while open the application from other network ,, NOw it works only local, i dont know what i did wrong ,then here follow the application, It does not able to work through remotely
I have done port forwarded in the router and i am sure this was worked that i seen a different IP adress in the iridium gate when i was access through my mobile
Now i dont know why it does not work
How to display the mode and status of KNX HVAC system
The KNX actuators are responding separate values as below;
Mode: | Comfort | Standby | Night | Protection | Heating | $21 | $22 | $24 | $A8 | Cooling | $41 | $42 | $44 | $C8 |- We are sending heating/cooling value as bit
- And sending the mode as byte
- But the byte value we are receiving is changing according to heating and cooling
- We are sending and receiving the Mode with the separated bytes
Please see the script sample how to do it:
HVAC.irpz
Change Subnet ID by script
IR.GetDevice(
"Relay"
).SetParameters({Subnet ID:
"101"
, Device ID:
"22"
})
Сервис поддержки клиентов работает на платформе UserEcho