1. i2 Control V2.2
  2. i2 Control V2.2
  3. Вопросы
0
Отвечен

set up position local bus and INT when I control automation system

Nguyễn Trực 9 лет назад в i2 Control V2.2 • обновлен iRidiumNikita 9 лет назад • 4
I'm control Lighting of myhome system. I want to expand system.I don't know setup local bus and INT of iridium. Now , I want to send 2 command to 2 address (A=1,PL=1 ,interface =main ) and ( A=1, PL=1, interface =2. I read document of automation system , I see they are setup I3,I4 of actuator.
I use to driver MyHome

Image 9584
Отвечен
Olga (expert) 9 лет назад
Dear Nguyễn Trực,


We work with already configured system. So, if you want to expand it you should address your question to MyHome.


Best regards,
Iridium mobile Support Team
Nguyễn Trực 9 лет назад
I don't know main website of myhome. Can You explain INT position and local bus above?
Nguyễn Trực 9 лет назад
i want to know who is write myhome driver of iridium. Can you tell me about Local bus and INT in myhome driver.
iRidiumNikita 9 лет назад
These parameters are used to build commands which sent to the device. Depending on the selected type SubType use a particular parameter (LIV or INT), or both.

About how make the commands, read the documentation for MyHOME and you may read this document OWN_intro.pdf

Best regards,
Iridium mobile Support Team

Сервис поддержки клиентов работает на платформе UserEcho