0
Завершен
Denon control thru iTach Serial
rocfusion 11 лет назад
в Готовые скриптовые модули
•
обновлен Ekaterina (head of support) 10 лет назад •
0
Take a Denon receiver and connect it to an iTach IP2SL with an serial cable.
First setup the iTach IP2SL with the serial parameters (note: most denons use this baud rate)
- Multiple Ports: Enabled
- Baud Rate: 9600
- Flow Control: None
- Stop Bits: 1
- Parity: None
- Data Bits: 8
Create a project and add the Denon driver to the project
Now in the connection setting of the Denon driver add the IP address of the Global Cache device (iTach IP2SL);
Change the port to 4999
Change the port to 4999
Create your interface with buttons and assign them to the commands of the denon driver.
Test it with the emulator or an control panel. This should work, in my environment this worked.
This driver is not officially supported by iRidium Mobile
Denon_v2.zip
Test it with the emulator or an control panel. This should work, in my environment this worked.
This driver is not officially supported by iRidium Mobile
Denon_v2.zip
Сервис поддержки клиентов работает на платформе UserEcho
