Uw opmerkingen

There is no parameter in the KNX driver that could cause it to be disabled. If the device is unavailable for a few seconds, the iridium is turned off. On KNX IP Router how many simultaneous connections are allowed? KNX IP Router handles connection breaks with it?

Hello.

Is the Host parameter an IP address or a domain name?

Does KNX IP Router have a static IP address or a dynamic one?

Добрый день.

В релизе 1.3.10 на Андроид драйвер SNMP работает корректно, возможные причины снижения производительности исправлены. Если у вас будут вопросы по этому поводу - пишите.

Your question is still left open, let us know if there will be problems with the server again.

At the moment, 2 versions of the Studio are available: the old (1.3.8) and the new. The old one is no longer updated and bugs in it are not fixed, but you can use it if it is convenient for you. Apparently you are installing a package that contains the current server and client versions, but the old Studio version. Also available is a package that includes a new Studio version (32 and 64 bit) and current client and server versions. You can see the server version in the web interface, in the upper left corner.

Make sure that the server version is up-to-date (1.3.10 at the time of posting this message). It is necessary to collect statistics: how often the kNX driver on the server goes offline, what preceded it, etc.

Does the KNX driver work in a server project or a panel project? What is the iRidium server/client version? How many iRidium panels/servers are connected simultaneously to KNX? Iridium client/server is on the same subnet as KNX IP Router?

1) Yes, this is a delay before polling the next address. All addresses in Feedback that have the "Read on start" option enabled are polled. It is recommended to enter DelayBetweenPolls from 100 MS with the number of addresses more than 100 PCs - to reduce the load on the bus. When polling more than 1000 addresses, the optimal delay is 500 MS.

2) In your case, it is necessary to find out why the driver is disconnected. With each new connection, it polls all addresses again.

Hello.

KNX - event driver. DelayBetweenPolls is intended only to determine the polling interval at the start of the project or connecting the KNX driver, if it was disabled during the work and then turned on again. If set to 0, requests go without delay. Latency can be useful if data is lost. They can get lost if you have a lot of addresses in the project. This partially corrects the delay between polls at startup. This delay is defined in DelayBetweenPolls (in MS). The SendTime parameter is used to delay before sending a command. If you have a constant polling addresses, you need to find out the reason. How many feedbacks in the project? How often does the KNX driver disconnect from the hardware?