0
Answered

Site license HDL bus pro

Andres Vallejo 8 years ago in i2 Control V2.2 updated by Dmitry - support (expert) 8 years ago 10

Hello


I have a question regarding the site license.


I have a site license in a bridge for HDL bus pro with few equipment and is already working, the site is a school with two buildings the first building is already working, Now I need to put a second bridge for HDL bus pro in the other building that has the same network.


My question is: do I need to buy another license for controlling the equipment connected to the second bridge even though is in the same network as the first bridge ?


Image 14703


Answered

Hello!


If you will have constant connection with the licensed controller, then you do not need a second license.

hello

Thanks for your reply


right now i2.2 is connected to the first bridge 10.117.108.99 that has the site license.

I think I need to change it to local broadcast 255.255.255.255 and test it again



Yes, when you use the local connection is better to use a broadcast

Hi Dmitry


I have change the panel to broadcast 255.255.255.255 but have the same result only works the equipment connected to the bridge 10.117.108.99 the one that has the site license.


I have made a quick test with iridium studio, I made 4 trigger buttons

In the first 2 trigger buttons I put channel 1 (command) and (feedback) of the relay connected to the bridge 10.117.108.99.


In the 3 and 4 trigger buttons I put channel 1 (command) and (feedback) of the relay connected to the bridge 10.117.108.98.


Now when I use the emulator on i3 with the developer panel test everything works fine.


So my conclusion is that: I need another site license for the other bridge?


Will this work with the same mask created for i2v2.2 ? I can see all the equipment from HDL with the scan udp option inside iridium.


The main problem is that I need to control both sides, that's the whole point of the site license.



Hello!

As I understand it, you was have a project configured for only one IP interface of the HDL (10.117.108.99). Then you just change the IP address into the driver of HDL 255.255.255.255.

Try to re-scan the network to add all the available devices. Site license should work, because for her, the main condition is the connection with the licensed controller.

If there is a connection with a licensed controller and the license received serial number, the project will work.

Hello


The project was always with 2 bridges and 1 site license but just last week the finally could make a connection from the second bridge to the first bridge and put them in the same network.


when I test it, I was surprise it didn't work, that's why I'm asking what can I do? to solve this problem?


Can you send the connection log and the project file to us by e-mail support@iridiummobile.ru?

Hello


I sent you the project file, everything was ok?


Hope to hear from you soon.

Hello


where do I get the connection log?, the project file I can send you.




Hello!


The connection log you can see if you press F4 on the keyboard while the emulator is running.