Vragen
0
Beantwoord
GC IP2IR sending from wrong port. LED flashes on wrong output
I have set thet Global Cache up, and it responds only on IR output 1, and 3.
When I try to send commands from port 2, LED flashes on IR port 1 and not on output 2, as should (and is set up to do...) All other ports are working fine.
What could that be?
I have tried to do a restart, I have tried other IR emitters, other IR codes.... (+++)
When I try to send commands from port 2, LED flashes on IR port 1 and not on output 2, as should (and is set up to do...) All other ports are working fine.
What could that be?
I have tried to do a restart, I have tried other IR emitters, other IR codes.... (+++)
Customer support service by UserEcho
As I think it would be incorrect settings of IR emitter in the iTach web-interface of incorrect settings of manually created command
It was my own fault. I had to manually test some codes, and I did some editing in the actual IR code - therefor the code wasn't sending correctlyout on the correct port.
I forgot to check the port number setting.
To solve this problem I had to manually change the port-settings from;
"sendir,1:1,1,37000,1,1,132,67,17,17,17...,...,..,..,,.7,17,17,17,2846"
to;
"sendir,1:2,1,37000,1,1,132,67,17,17,17...,...,..,..,,.7,17,17,17,2846"