fredrikml / Profile - Comments / iRidi

Delay in routine after movement of sensor

Hi,

I think i have confirmed that the sensor does the opposite of what is programmed in i3 lite. Made an easy routine with light on when movement. When entering the room no light was turned on during movement, however it was turned on when I stopped and was standing still

Med vennlig hilsen

Fredrik Meyer-Lampe

Vestre Rå 32b

Tlf 92485821

4 years ago

Delay in routine after movement of sensor

Hi, still not working.

I am not sure how I share my routine, however see attached picture.

I have removed the delay to make it easier to find the right programming.

The shown routine moves the gate, however it happens when there is movement, not no movement. Have you experienced that the HDL 8i1 sensors function is inverted?

Med vennlig hilsen

Fredrik Meyer-Lampe

Vestre Rå 32b

Tlf 92485821

4 years ago

Delay in routine after movement of sensor

Hi,

I have tried to get this to work, but do not succeed.

When implementing only the first routine, the garage door closes after two minutes, but not always. I have also experience that it opens the door, and I suddenly find the garage open during night time.

When I implement both routines nothing happens at all. I guess the stop routine stopps it all..

Are you sure the above is correct?

regards

Fredrik

5 years ago

Best way to integrate Z-wave

thanks, but which z-wave plugin are you using in iridium lite server ? Is the Vera plus used in addition to Iridium ?

5 years ago

Best way to integrate Z-wave

Did you manage to install the z-wave smart lock ? I have Iridium server running on a Raspberry PI. I have been able to use z-wave dimmer and switches by use of z-wave usb dongle zwave.me, but are not able to the my Z-wave Idlock to work. It finds my device, but is not able to sync services, so I can not control it

5 years ago

Delay in routine after movement of sensor

Hi,did not understand your proposal?

Med vennlig hilsen

Fredrik Meyer-Lampe

Vestre Rå 32b

Tlf 92485821

5 years ago

HDL bus prop - Feedback from Logic server and DLP …

Hi, did not find a function called monitor, but command test. Entered Logic module adresse 60 and got the attached signales. adresses

8 years ago

HDL bus prop - Feedback from Logic server and DLP …

Hi,

I have now set up the command "Universal Switch Status" with the same Universal number as my Universal Switch (101), Need confirm (Disable) and Use Timer (true) , Timer 3000ms

I have not linked it to any item.

I am still nota able to get any feedback about the UV 101 status on the Button where I have assigned the command UV 101.

Is it possible to the send project to you for fault finding or any other suggestions ?

8 years ago

HDL bus prop - Feedback from Logic server and DLP …

Hi,

Thanks for your reply.

1. I tried this but is not able to get any response, however I am unsure if I do it correctly.

I today Iridium with a multistate button to send UV 101 to the logic server. This works, but as mentioned I have different UV switches to the logic module (102, 103, 104, 105) and therefore want status in iridium.

I have found the function "READ STATUS OF UNIVERSAL SWITCH" both as command and feedback. Based on your reply I understand that you want me to assign it to a command.

Should I then add a command "READ STATUS OF UNIVERSAL SWITCH" with the mentioned timer etc, to the multistate button? If I do so I guess I have to press it before I get feedback ? Wouldn't it be more logic to use Feedback channel "READ STATUS OF UNIVERSAL SWITCH" (but it is not possible to configure timer 3000ms on feedback).

2. Will try the DLP as requested

thanks

8 years ago

Your comments

User menu